Transkript 1 Cat. Indholdsfortegnelse 2. Avanceret opstart eks. Den sidste mulighed er at bruge pulsindgangen med klemmerne RP og FC som feedback.

Author:Mushicage Shaktizragore
Language:English (Spanish)
Published (Last):26 May 2019
PDF File Size:2.82 Mb
ePub File Size:9.32 Mb
Price:Free* [*Free Regsitration Required]

Sarg 3t3mv from n to n can be displayed only. The length is automatically set by the CX-Protocol. Setting The Communications Data Communications Chapter 7 Setting the Communications Data The following description provides information on how to convert the regis- ter data such as monitor value or parameter set value data in the commu- nications data block of the message data such as DSR and response data.

Ensure that the installation conditions are met. Select peripheral devices which meet the specifications and wire correctly. Advanced Operation Chapter 6 Energy-saving Control The energy-saving control function automatically saves unnecessary power that is uselessly consumed while the load is light.

Next Process Determine which step is to be processed next or finish the operation after the step finishes normally. Terminal Block Design Chapter 2 Terminal Block To wire the terminal block of the Inverter, remove the front cover, terminal cover unless the Inverter is a V modelomrin bottom cover from the Inverter. Page of Go. Use Set Constant and set the constants in Hex. Use this information as a reference when deciding the number of Slaves to be connected to one network, and when considering the timing of input and output signals.

Page 53 Design Chapter 2 Cable length 50 m max. Please read this manual thoroughly and handle and operate the product with care. Transportation Precautions Caution Do not hold by front cover or panelinstead, hold by the radiation fin heat sink while transporting the product.

You have chosen to save the following item to a parts list:. You can zoom in close to see the labels with the serial number or zoom out to see the overall condition of the equipment. Chapter 5 Basic Operation Operation in Vector Control The Inverter in vector control mode calculates the omon of the operating condition of the motor. Please, use the noise filters as explained in Chapter Note This parameter 3g3v monitored only.

Doing so may result in injury. ON Multi-function input 6 1: Born to drive machines; v class three-phase input 0. Overtorque Detection Function Advanced Operation Chapter 6 Overtorque Detection Function When an excessive load is applied to omrin equipment, the Inverter detects the overtorque condition through an increase in the output current.

Not doing so may result in fire. The default unit omorn Hz. Advanced Operation Chapter 6 Note If set to vector control mode, the default value will be 0. The Inverter returns a response that consists of the Slave address, omfon tion code with the MSB set to 1, error code, and CRC check block when the communications error 3f3mv detected. Selecting The Reverse Rotation-prohibit Chapter 5 Basic Operation Selecting the Reverse Rotation-prohibit This parameter is used to specify whether to enable or disable the reverse rotation command sent to the Inverter from the control circuit terminals or Digital Operator.

It is possible to control the Inverter, give frequency references, monitor the Inverter status, and read and write parameters through communications. Not doing so may result in electrical shock or fire.

For example, if frequency reference 2 has been selected with multi-function input a multi-step speed referencethe set value in n for frequency reference 2 will be changed simultaneously when the fre- quency reference is changed 33g3mv the FREF indicator is lit.

TOP Related.


Omron SYSDRIVE 3G3EV User Manual



Bedienungsanleitung OMRON 3G3MV



Omron SYSDRIVE 3G3EV Handb├╝cher


Related Articles