Was ist beim Econobead zu beachten? Beim Econobead Beadfilter ist es wichtig, dass ein entsprechender Vorfilter verbaut werden sollte. Wo wird die Pumpe beim Econobead angeschlossen? Die Pumpe wird dann in Trockenaufstellung nach dem Siebfilter und vor dem Beadfilter installiert.

Author:Mazugul Gozuru
Language:English (Spanish)
Genre:Personal Growth
Published (Last):10 September 2013
PDF File Size:6.23 Mb
ePub File Size:15.56 Mb
Price:Free* [*Free Regsitration Required]

This comes in handy when you are treating the pond. You can also use the waste setting to vacuum out your pond without the garbage going into your filter, it bypasses the EconoBead filter via the multiport and goes out to waste.

It is impossible to get every little bit of debris out of a filter and this causes these minute particles to exit in the waste line instead of going back into the pond. The water enters the EconoBead filter from the top spray bar C and exits the vessel at A and goes out to waste. Keep it open for seconds, and then shut it. This will purge the large solids that have made it into the EconoBead filter and settled out in the bottom of the tank to waste.

It is very important to get them out of the system for overall water quality and more efficient filter operation. Turn off pump. Move multiport valve to rinse. Air will go out of the EconoBead filter to waste and a small amount of water when blower is activated. Activate blower unit for minutes. During this time the beads and debris is dispersed throughout the interior of the EconoBead filter. This breaks up all trapped particles in the filter allowing the debris to be easily backwashed out to waste.

Move multiport valve to backwash mode. Turn pump on and run until backwash water is clear. Turn pump off. Move multiport valve to rinse feature. Turn pump on and run until water is clear. This takes any leftover debris that would have gone back into the pond and sends it to waste instead of sending a grunge cloud of debris back into the pond.

Move multiport valve back to EconoBead filter position and restart pump. After you become familiar with the backwash process you can accomplish the backwash cycle completely in about 4 or 5 minutes. Every pond is different; however most people find that backwashing needs to be done once or twice a week.


EconoBead® EB-60 Filter-Set



Econobead Beadfilter EB-60 ├ś 600 mm Anschluss 63 mm


Related Articles